![]() The heat dissipation of the integrated circuit is very important, since the temperature determines the life of the integrated circuit. The power supply to be used for this project must be capable of supplying 2 amps. ![]() Since it is only one channel, 2 channels must be made to use it in stereo. In this graphic we can see the placement of the components of this amplifier, we must pay attention that the negative connection to the current or ground is only mixed in the leg 3 of the integrated circuit, if we mix the ground of the speaker and the input can produce noise and unwanted oscillations. Then it is necessary to increase the R2 value, even more than 33 ohms. Noise may be produced by too much gain or sensitivity of the amplifier. If it is to be connected to the output of the computer or a player, noise can be produced by too much gain or sensitivity of the amplifier. If the source is well rectified and there is not much wire distance it can be 470 microfarads. ![]() If we want more gain we increase the value of R3.Ĭ3 1000 microfarads 16 volts (at 10 volts works well)Ĭ4 0.1 microfarad, some represent it as 104. R2 is 3.3 ohms (less than 10 ohms*, greater than 2) R1 is 1000 ohms, it can be small (less than 1/8W). Trying not to sacrifice high notes (treble or trills). If you want better bass it can be 10 microfarads.Ĭf can be 470 picofarads, if there is noise it can be of higher value. ![]() Pot1 is a logarithmic potentiometer from 10K to 50K.Ĭ1 if not for "Woofer" can be 1 or 2.2 microfarads from 10 volts and up. Using a TDA2003 and a few components we have a good amplifier that can work to amplify the audio output of our computer or as a test amplifier.Īccording to the manufacturer the TDA2002 is 8W and the TDA2003 is 10W.Ĭonnections, component values and voltage are the same.įor test instruments they can work with 9 Volts, as power amplifiers they work perfect with 14 volts, and it is better not to reach 18V. ![]() One of the easiest amplifiers to build (I will show the diagram and drawing). Many times I have wanted to make an audio amplifier of very good quality but there are many plans with very basic integrated circuits so I have searched and I have found an IC that has an excellent audio quality and with a supply voltage of 12VDC. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |